How to ensure the quality of egg tray production equipment

2022-09-24 14:54:11

Generally, the temperature in the drying tunnel of the egg tray machine can usually reach 105-200 degrees Celsius. No matter which drying equipment is selected, it is required that the equipment itself has a good thermal insulation layer to prevent heat loss, and the structure of the equipment should be able to ensure that the temperature of the internal parts is uniform.

At present, there are two main methods for obtaining hot air. One is to generate hot air directly by burning it in a hot blast stove. The other is to use steam to generate hot air through heat exchange with air. Hot air is used as the drying medium in the drying tunnel, and the heat source can be coal, fuel oil or natural gas.

Therefore, to ensure the quality of egg tray production equipment, special attention should be paid to raw materials. Only by guaranteeing the quality and safety of the raw materials can you finally get the products and make the most of them. Most do not guarantee the safety of raw materials, which can lead to substandard overall quality.

As an extra note, since the egg tray will shape the pulp, the pulp will stick to the pulp pot and the tray will get dirty around the tray. These need to be cleaned in a timely manner, not only to ensure that the egg tray machine is clean, but also to wear out the machine if too much pulp residue accumulates.

When cleaning the egg rack machine, please avoid using hard steel wool, chemical rubbing or steel brushing, please use a soft towel, a soft cloth to wipe with water or use a neutral cleaner, otherwise it will cause scratches or corrosion. The egg tray equipment is made of stainless steel, and under normal conditions, the egg tray equipment will not rust.

However, cards can rust if they are not used or maintained properly, or if the environment of the card is too poor. It is necessary to improve the maintenance awareness of the egg tray machine and do a good job in maintenance. Improper use of the card can lead to rust and degumming. Attention should be paid to the correct use of methods to prevent the occurrence of these two phenomena.